Cabletown is not designed for use with mobile devices. To see it in action, check out one of the videos below:

Simple Harness
Ethernet Breakout
Multi-ended Harness

Login Register Logout

Add Wire

Select a Vertex or Connector
Hover over another Vertex, Connector, or Lane
Click anywhere to finish

Add Twist

Select a Wire
Select another Wire

Add Connector

Hover a Vertex without a Connector attached to it
Click anywhere to finish

Add Edges

Click in empty space, or on a Vertex or Edge. Right-click to finish
Click in empty space, or on another Vertex or Edge. Right-click to cancel Edge

Add Cable/Tube

Select a Vertex or Connector
Hover over another Vertex, Connector, or Lane
Click anywhere to finish

Add Heatshrink

Select a point on a Lane
Select another point on the same Lane

Add Note

Select a Vertex or Edge
Click again to set location

Add Distance Relation

Select a Vertex
Select another Vertex

Add Angle Relation

Select an Edge
Select another Edge

Break Edge

Select an Edge to break it in two

Mend Vertex

Select a Vertex connected to two Edges

Insert Wire Into

Select a Wrap (Cable, Tube, or Twist)
Select any number of Linears to (Wire, Cable, Tube, or Twist) to insert. Click OK to finish

Extract Wire From

Select a Wrap (Cable, Tube, or Twist)
Select a Linear (Wire, Cable, Tube, or Twist), which the is inside the Wrap

Trim

Select a Wrap (Cable, Tube, or Twist)
Select a point along the selected Wrap to trim from
- Optionally hover a Vertex to specify which end to trim to

Add Loop

Select a point along a Lane